Oreck UK2200 User Manual page 6

Maintenance: Changing the Filtration Bag
SaniSeal ® OPERATION
: Your Oreck
SaniSeal System. SaniSeal automatically locks in allergens, dirt and debris each time you change
® ®
the bag.
IMPORTANT NOTE:
To keep your vacuum running at optimal performance, make sure to
change the filtration bag when the contents reach the MAXIMUM FILL LINE. Overloading may
result in loss of air flow suction and decreased performance.
1
Unzip the Filtration Bag Case
completely. Pull the cardboard
collar to release bag dock door
from filtration bag port. Bag dock
door will hinge downward.
3
Slide the cardboard collar
completely onto bag dock door.
CAUTION
VERY FINE MATERIALS, SUCH AS FACE POWDER OR CORNSTARCH MAY SEAL THE FILTRATION
BAG AND CAUSE IT TO BURST EVEN THOUGH IT IS ONLY PARTIALLY FULL. CHANGE OFTEN WHEN
CLEANING THIS TYPE OF MATERIAL.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY, UNPLUG BEFORE CLEANING OR SERVICING. DO NOT USE
VACUUM WITHOUT FILTRATION BAG IN PLACE.
10
vacuum includes a filtration bag equipped with the
®
2
Gently pull cardboard collar
upward out of the bag
dock. SaniSeal will close
®
automatically.
ENFONCEZ JUSQU'À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
11 8
4
Firmly push bag dock door with
both thumbs on indication points
until it snaps. Zip up the filtration
bag case completely.
Maintenance: Adjusting or Replacing Brushroll
NOTE: Your Oreck unit comes with the brushroll assembled in the "NEW" position (multiple
®
notches showing on top edge). As the brushroll wears it can be adjusted for longer life.
NOTE: When rotating the black endcaps on the brushroll, make sure both endcap settings are the
same and face up when you insert the brushroll.
1 2
Lay the unit flat Remove the brushroll
to access the belt and brushroll from
power head nozzle. the holding channels
Remove the 5 screws inside of the power
to take off the head nozzle.
baseplate from the
power head.
4 5
Reassemble the Manually spin the
brushroll belt. brushroll to see that it
Reference the turns freely.
Maintenance Section
on Checking and
Replacing the Brushroll
CONTACT OUR CUSTOMER CARE LINE
Belt for details.
1-800-989-3535
WARNING
TO REDUCE THE RISK OF ELECTRIC SHOCK AND INJURY FROM MOVING PARTS - UNPLUG BEFORE
CLEANING OR SERVICING.
3
When worn, rotate both
plastic black endcaps at
the ends of the brushroll
to show a single notch
"OLD" position. Insert
back into the holding
channels of the power
head nozzle.
6
Replace the 5 screws
to secure the
baseplate to the power
head nozzle.
(Mon-Fri 7 a.m. – 7 p.m. CST; Sat 8 a.m. – 4:30 p.m. CST)
11