Page 1
INSTRUCTIONS FOR USE R for Rabbit's CHILD CAR SEAT GROUP 0+ M o d e l : P i c a b o o SUITABLE FROM BIRTH – 15 MONTHS SUITABLE FROM APPROXIMATELY 0 TO 13KGS NOTICE 1.This is a “Universal” child car seat; it is approved to ECE Regulation 44.04 for general use in vehicles and will fit most vehicle seats.
Contents NOTES ......................2 SAFETY WARNINGS ..................3 PARTS AND INTERIOR EQUIPMENT .............. 4 ADJUSTING THE SHOULDER HEIGHT ............5 THE ADJUSTMENT AND USE OF HARNESS..........5 SECURING THE INFANT CARRIER ..............6 SNAPPED THE HANDLE .................. 8 CANOPY ASSEMBLY ..................9 MAINTAIN AND CARE OF YOUR PRODUCT ..........
NOTES 1. Please read through these instructions carefully before using the baby car seat for the first time. The instructions can be retained on the baby car seat for reference in its life period. Applicability: The baby car seat is suitable for weight categories 0+, (No older than approx.
PARTS AND INTERIOR EQUIPMENT PARTS AND INTERIOR EQUIPMENT Car seat-Picaboo Parts Drawing Red Button Handle Adjuster Red Button Handle Adjuster Carry Handle Carry Handle Harness Adjuster under “Press” Shoulder Harness Sl s Harne Adjuster Strap Diagonal Belt Guid e Cover...
ADJUSTING THE SHOULDER HEIGHT The harness has 2 positions. The straps should go into the slots at, or the nearest slots above the height of the child’s shoulders. Remove straps by passing them through the slots from the front to the back of the seat to adjust the harness: re-route the straps through the appropriate slots.
2.S ecu rin g t he ba by w it h th e ha rne ss Fir stl y, adj ust shou lder str aps hei ght( see poi nt ADJUSTIN G THE SHOULDER ) , p roce ed as f ol lows: HEIGHT Step 1.Lo osen th e ha rness (see poi nt abo ve), open th e bu ckle, an d pl ace the m down side ways.
Page 8
fig 1 which you are traveling) Step 1. Adjust the handle to the forward position (Fig. 1). Put the seat in car's seat. Handle must be firmly against the backrest of car's seat Fig. 1 Step 2. Slide the lap belt of the Vehicle’s 3-point seatbelt through both Lap belt guides.
Make sure all the belts` position is right and they has not become twisted. Also check that the cover is not impeding the movement or fit of the belt webbing in any way. To release your baby car seat following the above instructions in reverse order. SNAPPED THE HANDLE T he h andl e f or t he b aby ca r se at can be s napp ed i nto 4 s tabl e po sit ions .
MAINTAIN AND CARE OF YOUR PRODUCT REMOVE (CLEAN) THE COVER The cover can be easily removed for washing. Remove harness by pressing the harness and loose the shoulder straps to release buckles; then remove the cover to wash in warm water. Follow reverse of the above to replace the cover.