Table of Contents
Advertisement
Connecting and Adjusting
the Headset
Insert the headset's plug into the jack
on the side of the remote keypad.
Put on the headset, and adjust the
band until it rests with almost no
pressure on your ear and the top of
your head.
If the headset is loose, remove it and
gently push the headset band inward
slightly to tighten it. If the headset is
tight, gently pull the headset band out
to loosen it.
Hold the headset in place, and turn the
microphone boom until it is about 2
inches from your mouth.
When you are not using the headset,
place it on the headset holder.
Setting the Ringer
To have the phone ring when a call
comes in, set
RINGER ON/OFF
remote keypad to
. To turn off the
ON
ringer, set it to
. With the ringer set
OFF
to
, you can still make outgoing
OFF
calls. If you hear an extension
telephone ring, you can answer the
incoming call on this phone. The
TALK/LOW BATT indicator and the IN
USE/CHARGE indicator flash until you
answer the call.
Setting the Dialing Mode
Set
at the bottom of the
TONE/PULSE
base for the type of service you have.
If you are not sure which type you
have, do this simple test after charging
the battery pack.
1. Set
TONE/PULSE
2. Lift the remote keypad from the
base and press
the TALK/LOW BATT indicator
and the IN USE/CHARGE
indicator, then listen for a dial
tone.
3. Press any number other than 0
and 1.
Note: If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access code
either.
If the dial tone stops, you have touch-
tone service. If the dial tone continues,
you have pulse service.
If you have tone service, leave
set to
PULSE
on the
service, set
To hang up, place the remote keypad
on the base or press
Using the Belt Clip
Use the belt clip to hang the remote
keypad on your belt or waistband for
hands-free carrying.
7
to
.
TONE
so
TALK/HANG UP
TONE/
. If you have pulse
TONE
to
.
TONE/PULSE
PULSE
.
TALK/HANG UP
Advertisement
Table of Contents
