Targets Menu - GE L90 Instruction Manual

TARGETS MENU

7.1.5.2 Collecting synchronized measurements ad hoc
The one-shot feature can be used for ad hoc collection of synchronized measurements in the network. Two or more PMUs
can be pre-scheduled to freeze their measurements at the same time. When frozen, the measurements can be collected
using the EnerVista software or a protocol client.
7.1.6 Security
COMMANDS  SECURITY
 SECURITY

With the CyberSentry option, this setting is available to enable or disable the following commands.
ADMINISTRATOR LOGOFF
ENGINEER LOGOFF
OPERATOR LOGOFF
CLEAR SECURITY DATA
operands associated with the self-tests.
7.2 Targets menu
7
A target enables the EnerVista UR Setup software to monitor automatically and display the status of any active target
messages of all the devices inserted into that site.
Each L90 element with a TARGET setting has a target message that when activated by its element is displayed in sequence
with any other currently active target messages in the
Element 48 target settings are active and so have their targets displayed. The down arrow below the two elements
indicates that there can be other active elements beyond these two.
For more information, see the description of target messages in the next section, and the Introduction to Elements section
in the Settings chapter for instructions on TARGET setting.
When no targets are active, the display reads
7-6
ADMINISTRATOR

LOGOFF: No
ENGINEER

LOGOFF: No
OPERATOR

LOGOFF: No
CLEAR SECURITY DATA:

No
— Selecting 'Yes' allows the Supervisor to forcefully logoff an administrator session.
— Selecting 'Yes' allows the Supervisor to forcefully logoff an engineer session.
— Selecting 'Yes' allows the Supervisor to forcefully logoff an operator session.
— Selecting 'Yes' allows the Supervisor to forcefully clear all the security logs and clears all the
TARGETS
PHASE TOC4

OP: A B -
DIGITAL ELEMENT 48:

LATCHED

NO ACTIVE TARGETS
Range: Yes, No
Range: Yes, No
Range: Yes, No
Range: Yes, No

Displayed only if targets for this element are active.
Example shown.
Displayed only if targets for this element are active.
Example shown.

menu. In the example shown, the Phase TOC4 and Digital
TARGETS
.
L90 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
CHAPTER 7: COMMANDS AND TARGETS