Troubleshooting - VuQube Vu Qube V10 Installation And Operating Manual

Satellite Position Memory
TO STORE POSITION: Hold down either the Satellite 1 or Satellite 2 button
for at least 2.5 seconds. The LCD will show "P1" or "P2" when button is
released.
TO RECALL POSITION: Hold down either the Satellite 1 or Satellite 2
button for less than 2.5 seconds. The LCD will show "r1" or "r2".
TO CANCEL RECALL: Press any arrow button to stop moving to a stored
position.

Troubleshooting

If you cannot lock on to the correct satellite, it is most likely that an object
is blocking the signal. If this is the case, move the vehicle to have an
unobstructed view of the southern sky.
ERROR CODES
E0
E1
E2
Vu Qube
PROBLEM
Remote is unable
to send commands
to antenna
Remote is unable
to receive response
from antenna
Miscommunication
between remote
and antenna
ACTION
is attached to receiver
Move remote closer to antenna
Call Wallace Technologies @
866-802-2228
11 V10-6/1007