Explanation Of The Parameters - Siemens SIMATIC ET 200AL Manual

4.2

Explanation of the parameters

Diagnostics: No supply voltage 2L+
Enabling of the diagnostics for no or insufficient supply voltage 2L+.
Diagnostics port
This parameter enables the diagnostics for the selected port.
The diagnostics possible depends on the IO-Link device in use. Additional information about
the diagnostic interrupts can be found in the description of the utilized IO-Link device.
Input / output type
This parameter sets the maximum length of the input and output data of the module.
Port configuration without S7-PCT
This parameter releases the port configuration without S7-PCT for the module.
Port Qualifier Information
This parameter releases the Port Qualifier Information (PQI).
The PQI provides information on the device status of the port and IO-Link.
Operating mode
This parameter determines the mode in which the selected port should be operated.
You can select from the following options:
● IO-Link autostart
● IO-Link manual
● DI
● DQ
● Disabled
IO-Link autostart
The connected IO-Link device starts automatically (Plug&Play functionality). The IO-Link
device is immediately ready for operation.
Communication module CM 4xIO-Link 4xM12(6ES7147-5JD00-0BA0)
Manual, 10/2017, A5E32352322-AE
Parameters/address space
4.2 Explanation of the parameters
21