Sending Dtmf Tones - Motorola IHF1700Music Motomanual

Transferring a Private Call to Handsfree
1 Press and release the Multi-Function button.
The handsfree system responds: Call menu. {Say a command}.
2 When prompted, say "Handsfree mode".
The handsfree system responds: Handsfree mode and transfers the call to the handsfree
system.
Or use the UIM: During a private call, a press and hold of the Send button will transfer the
call to the handsfree system.
Note: Some handset devices will disconnect the Bluetooth link to the system when the call is
switched to privacy mode. In this case the 'Call menu' will not be available. To switch the call
to handsfree, use the UIM.

Sending DTMF tones

1 Press and release the Multi-Function button.
The handsfree system responds: Call menu. {Say a command}.
2 When prompted, say "Enter <digits>" to send digits as DTMF tones. You can also use *
and # characters.
Tip: You can send DTMF tones from the handset device's keypad.
Placing the Call on Hold
A press and release of the Send button will put the active call on hold.
Resuming the Held Call
A press and release of the Send button while a call is held will resume the call.
Accepting a Waiting Call
When you are in a call, an audible beep signals an incoming call. The Blue LED will flash fast.
Press and release the Send button to place the active call on hold and answer the waiting
call.
The Blue LED will stop flashing fast when the waiting call is accepted.
Rejecting a Waiting Call
While there is a waiting call, a press and release of the End button to reject the waiting call.
Switching between Active Call and Held Call
1 Press and release the Multi-Function button.
The handsfree system responds: Call menu. {Say a command}.
2 When prompted, say "Switch call".
The handsfree system responds: Switching active calls.
Or use the UIM: A press and release of the Send button will switch between the held and
active calls.
Ending the Active Call while a Call is Held
1 Press and release the Multi-Function button.