Getting Started; Installing The Antenna; Installing And Removing The Battery; Installing The Battery - Midland Syn-Tech III P25 Operation Manual

2

Getting Started

2.1

Installing the Antenna

The antenna should be attached to your radio
before use. Using your radio without the
antenna may damage the radio.
1. Align the base of the antenna with the
socket on the top of the radio.
2. Screw it all the way into the socket.
Be sure that antenna seats properly.
2.2

Installing and Removing the Battery

The battery should be charged
before use. The battery may be
charged while installed or
removed from the radio.
2.2.1

Installing the Battery

1. With the belt clip facing up and LCD
facing down, position the battery
leaving approximately ½ inch
space between the top of the
battery and the battery latch.
Three mating clips help you to
align the battery.
2. Slide the battery all the way up
to the battery latch, until you feel
and hear a click.
2.2.2

Removing the Battery

1. With the belt clip facing up and
LCD facing down, push the
battery latch to the right until it
stops.
2. Slide the battery away from the
latch about ½ inch.
3. Separate the battery from the
radio by lifting up, away from the
radio.
680-090-2040
Version 5.0eng
2
http://www.midlandradio.com
Syn-Tech III P25 Portable Radio
OPERATION MANUAL
Figure 2.1 – Installing the Antenna
Figure 2.2 – Installing the battery
Figure 2.3 – Removing the battery