Advertisement
Safety Clutch
If the tool insert becomes caught or jammed, the
drive to the drill spindle is interrupted. Because of
the forces that occur, always hold the power tools
firmly with both hands and provide for a secure
stance.
If the power tool jams, switch the machine off and
loosen the tool insert. When switching the
machine on with the drilling tool jammed, high
reaction torques can occur.
Switching On/Off: A
To start the machine, press the On/Off switch 6
and keep it depressed. To switch off the machine,
release the On/Off switch 6.
Setting the Speed/Impact Rate
The electronic control 10 enables stepless speed
and impact pre-selection in accordance with the
material to be worked.
The maximum hammering capacity is achieved
when the thumbwheel 10 is set to position "6".
5) Maintenance and Service
a. Maintenance and Cleaning
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the
machine and ventilation slots clean.
A damaged dust protection cap should be
changed immediately. We recommend having this
carried out by an after-sales service.
Clean the tool holder 2 each time after using.
Important:
When the carbon brushes wear below acceptable
service tolerances, the machine will automatically
cut out. The machine must be sent to customer
service for maintenance.
OPERATION INSTRUCTION
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for power tools.
In all correspondence and spare parts order,
please always include the article number given on
the type plate of the machine.
b. Disposal
We recommend subjecting electric tools,
accessories and packaging to a recovery process
that respect the environment.
Do not throw away electric tools!
for EU countries only: in accordance with
European Directive 2202/96/EC on
unserviceable electric and electronic
apparatus, after transportation into
national law, electric tools must be
collected separately to subject them to
ecologic recycling.
Subject to change without notice.
c. Technical data
ipm
e
STEEL
CONCRET
WOOD
L
WA
L
pA
6
= Power input
= Load Speed
= Percussion
= Percusive energy
= Insertion
= Maximum drilling, steel
= Maximum drilling, concrete
= Maximum drilling, wood
= Weight
= Sound power level WA
= Sound pressure level P
= Vibration
Advertisement
