User Interface Settings - JVC KW-V640BT Instruction Manual

Settings Settings

User interface settings

Display the <User Interface> screen.
On the Home screen, touch as follows:
Then, on the <SETUP> screen, touch [User Interface].
<Steering Remote Controller>
Assign functions to the keys on the remote controller
of the steering wheel.
• This function is available only when your car is
equipped with the electrical steering remote
controller.
• You can only register/change the functions while
you are parked.
• If your steering remote controller is not compatible,
learning may not be completed and an error
message may appear.
1
When the unit is ready for learning, press
and hold a steering remote controller
button for about 2 seconds to register/
change.
• Refer to the message displayed to confirm
whether the unit ready before proceeding.
36 ENGLISH
2
Select a function to assign to the selected
button.
3
Repeat steps 1 and 2 to register other
functions to other buttons.
4
Touch [Learning completed] to finish
procedure.
A confirmation message appears. Touch [Yes].
• The unit can register/change all of the buttons'
functions at the same time. To do this, press all
buttons in turn and after pressing all of them, touch
[Learning completed] in step 2. However, new
functions cannot be learned after this operation.
• When changing the functions already learned, touch
the assigned function you want to change in step 2
and then touch to select the new function from the
function list.
• Confirm the contents of the settable functions in the
function list. You cannot edit the function list.
To initialize the setting: Touch [Learning
initialisation] in step 2.
• A confirmation message appears. Touch [Yes].
– To cancel the initialization, touch [No].
<Beep>*
• ON (Initial): Activates the key-touch tone.
• OFF: Deactivates the key-touch tone.
* Available only when <X'over Network> is set to [2way].
<Language Select>
Select the text language used for on-screen
information. For details, see "Initial settings" on
page 4.
<Touch Panel Adjust>
Adjust the touch positions of the buttons on the
screen.
Touch and hold the center of the marks at the lower
left (1), then the upper right (2) as instructed.
(Hold)
• To reset the touch position, touch [Reset].
• To cancel the current operation, touch [Cancel].
<Clock>
Select the method to set the date and clock. For
details, see "Calendar/clock settings" on page 5.
(Hold)