Pioneer FH-MG6106ZH2 X1H/UC Service Manual page 76

FH-MG6106ZH,MG6106ZH2
- How to remove the Pickup unit
1. Remove the pulling spring, torsion spring and E-
shaped ring. Then remove the Clamper arm.
* The spring (A) will be removed with the Clamper
arm.
2. Slide the Clamp UP lever (B) to remove it.
3. Loosen the 2 screws. Remove the feed-screw cover
by sliding it.
4. Remove the feed-screw pressure spring (D).
5. Loosen the 2 screws. Remove the feed-screw holder
(E).
6. Remove the belt.
8. Loosen the 2 screws. Remove the plate spring and
the rack.
9. Pull out the feed screw from the Pickup unit.
76
Carriage
motor
Pickup
unit
Belt
Feed screw
Grease (Yellow:
PG-641)
Pulling spring
Torsion spring
7. Remove the Pickup unit together with the feed screw.
* Be careful not to lose the shaft holders at the both
ends of the feed screw.
* Be careful not to damage the 2 flexible PCBs(for the
Pickup and motor) when separating them. The flexi-
ble PCBs have been stuck each other with double-
sided adhesive tape.
White
Black
Fig.8
Feed screw
Pickup
unit
E-shaped ring
Clamper arm
Fig.7
Plate spring
Rack
Grease (White: KD-1)
Grease (Yellow:
PG-641)
Fig.9