Pioneer FH-MG6106ZH2 X1H/UC Service Manual page 75

- How to remove the Carriage Mech Assy
1. Insert a short pin into the flexible PCB of the Pickup
unit.
2. While opening the resin hooks, remove the cover
from the Servo unit.
3. Disconnect the flexible PCBs from the connectors
CN101 and CN301.
4. Remove the Tray holder and the Tray assy. (See
above)
5. Rotate the Cam gear motor until the positions of all
holes (E) match, then stop the motor.
(The Carriage Mech assy will stop as shown in the
Fig.5.)
Cover
Short pin
CN101
10. Remove the screw, pressure spring and collar. Lift
up the Carriage mechanism assy to remove it.
Flexible
holder
CN301
FH-MG6106ZH,MG6106ZH2
* When the positions of all holes match, they will be
completely covered by the Carriage mech assy.
* To rotate the Cam Gear motor, see "How to remove
the Tray assy".
6. Unhook the spring A.
7. Remove the flexible holder B (while opening the
hooks).
8. Remove the flexible PCB (C) from the motor. (The
flexible PCB (C) has been stuck on the motor with
double-sided adhesive tape.)
9. Loosen the fixing screw and remove the flexible
holder.
Match the hole positions
Fig.5
Pressure spring
Screw
Collar
Carriage mecha-
nism Assy
Fig.6
75