How To Set On Pc Board; Operating The Timer Remote Controller (Cz-Rtc2) - Panasonic S-22MM1E5A Installation Instructions Manual

8-1. How to Set on PC Board

1. Turn off the power breaker to halt the supply of electricity to
the PC board.
2. Open the cover of the electrical box and confirm that there is
the indoor unit control PC board in it.
When using with high static pressure mode, set the indoor unit
control PC board as shown in Fig. 8-1.
3. Connect the short circuit connector to the short circuit pin
TP3 (2P: Yellow) of the indoor unit control board.
● In the case of wired remote control setting, do not use
the short circuit connector.
8-2. Operating the Timer Remote Controller
(CZ-RTC2)
8-2-1. How to set the external static pressure
1. Press and hold down the
simultaneously for 4 or more seconds.
( , the Unit No., Item Code and Detailed Data will
blink on the LCD display.)
2. The indoor unit numbers in the group control will be
sequentially displayed whenever the Unit Select button is
pressed .
Only the fan motor for the selected indoor unit will operate
during this time.
3. Specify the " " item code by pressing the
buttons for the temperature setting
/
buttons and confirm the values.
(" " set at shipment )
4. Press the /
buttons for the time to amend the
values for the set data.
Refer to Table 8-2 and Fig. 8-2 and select a value "
5. Press the button.
The display will stop blinking and remain illuminated.
6. Press the button. The fan motor will stop operating and
the LCD display will return to the normal stop mode.
AMP Air Conditioning
, and buttons
".
Table 8-1 External static pressure
Type
Standard (Pa) (shipment)
High static pressure (Pa)
Indoor Unit control PC board
IC001
Table 8-2 Setting the external static pressure
Indoor unit
15 22 28
External static pressure of the rated air flow
volume (Pa)
10 15
30 30
1 6 5
1
NOTE:
Failure to set this parameter may result in decreased airflow
and condensation.
20
www.ampair.co.uk | sales@ampair.co.uk
15 22 28 36 45
10 15 15
30 30 40
White Yellow Red
TP6 TP3 TP1
IC010
JP001
CN073
FILTER EXCT
CN044 CN040 CN041
RC
EMG OC
Item code
36 45 56
15
40
4
CZ-RTC2
56
T5A E250V
Fig. 8-1
2
3