Boiler Adjustment Record - Biasi ADVANCE 25C User Manual And Installation Instructions

two ignitions when the boiler functions in
normal on/off heating mode.
• Press button for more than 3 seconds to
enter in mode (Fig. 8.26).
0
21 3
1 8 6
9
1 5
1 2
Fig. 8.26
• Press buttons
time to enter transparent programming
(Fig. 8.27).
Fig. 8.27
• Press buttons
the "PM10" program for selecting the igni-
tion frequency (Fig. 8.28).
Fig. 8.28
In Fig. 8.28 a SET programmed at 90 is dis-
ADVANCED COMMISSIONING
and at the same
or to display
played corresponding to a re-ignition time of
about 3 minutes.
The adjustment field is from 0 to 8 and half
minutes.
Each step increased or decreased corre-
sponds to 2 seconds.
• To modify the programmed SET, act on
buttons or
number programmed to flash (Fig. 8.29).
Fig. 8.29
• To exit programming, press button .
8.5

Boiler adjustment record

Important: at the end of the settings op-
eration it is important to update the table
with new settings (Fig. 8.30).
This is to allow the correct setting of this
boiler in case of replacement of the main
control p.c.b.
PARAMETER
Boiler type (to be up-
dated with the com-
plete range)
Type of water sensors
(C.H. / D.H.W.)
Pump speed
Zone valve setting
Room Thermostat /
Remote Control
Gas type
D.H.W. maximum tem-
perature °C
and wait for the
DIGIT VALUES
Pr 01
Pr 02
Pr 03
Pr 04
Pr 05
Pr 06
- 71 -