Servicing Procedures - Mitel ST100DA Quick Install Manual

Connections

Servicing Procedures

WARNING: The ST100DA contains no internal field serviceable parts. Return the equipment to Mitel
for any required service procedures.
CAUTION: Internal fuses should be serviced only by qualified Mitel personnel. If internal fuses are
blown and require replacement, return the ST100DA to Mitel for service.
WARTUNGSVERFAHREN
ACHTUNG: Der ST100DA enthält keine internen Teile, die vor Ort gewartet werden können. Senden
Sie das Gerät an Mitel, falls Wartungsarbeiten erforderlich sein sollten.
VORSICHT: Interne Sicherungen dürfen nur von qualifizierten Mitel-Mitarbeitern gewartet werden.
Wenn interne Sicherungen ausgetauscht werden müssen, senden Sie den ST100DA zur Wartung an
Mitel.
Connecting the Mitel Voice Switch to the Network
Once the ST100DA Voice Switch is secured to a rack or placed on a surface, you can connect it to
the data network.
Powering on the Mitel Voice Switch
After connecting the switch to the network, power on the device by connecting it to an AC power
source.
1. Plug an AC surge protector (not provided) into a grounded AC power source.
2. Plug one end of the provided power cord into the receptacle on the back of the switch, then
plug the other end into the AC surge protector.
The power LED flashes momentarily, and remains lit.
• If the LED is not lit, make sure the power cord is plugged into the switch and the power source.
• If the LED continues flashing, there is an internal error. Unplug the switch to power it off, then
power it back on. Refer to the "Configuring Switches" chapter in the Mitel Connect System
Administration Guide for information on flash patterns, or contact Mitel Support Services at
http://www.mitel.com/shoretel.
The LAN ports auto-sense the network transport rate. When the network connection is established,
the network LED indicates a transport rate of 10, 100, or 1000 Mbps, and whether the switch is
receiving and transmitting data.
Use an RJ-45 Ethernet cable to connect one or both of the LAN ports
to the network subnet.
While both ports can detect and respond to link status, the switch cre-
ates a data connection on only one LAN port at a time.