Related Manuals for Mitel ST2D
Summary of Contents for Mitel ST2D
- Page 1 ST1D/ST2D Voice Switches Quick Install Guide Mitel Networks Corporation 350 Legget Dr. Kanata, Ontario K2K 2W7 Canada +1.844.937.6483...
- Page 2 • RJ-48C Telco port(s) for connecting the switch to telephone company lines. The ST1D has one RJ-48C Telco port, and the ST2D has two RJ-48C Telco ports. These are the T1/E1 configurable connections. *This document also applies to ShoreTel-branded models of the same model number:...
-
Page 3: Installation Equipment
Installing the ST1D/ST2D on a Wall The ST1D/ST2D is placed on a wall by attaching the ST Voice Switch Wall Mount Bracket to the wall, and then attaching the appliance to the bracket. Refer to the ST Voice Switch Wall Mount Bracket Quick Install Guide for more information. -
Page 4: Servicing Procedures
If the LED continues flashing, there is an internal error. Unplug the switch to power it off, then power it back on. Refer to the “Configuring Switches” chapter in the Mitel Connect System Administration Guide for information on flash patterns, or contact technical support at http://www.mitel.com/shoretel. -
Page 5: Configuration And Status
Configuration and Status Network Configuration Once the Mitel voice switch is installed and powered on, it must be configured for network operations. A switch gets a network configuration by assignment from a DHCP server, or directly from an administrator console (see procedure below). -
Page 6: Specifications
Operating temperature 0-50˚ C Copyright © 2018 Mitel Networks Corporation. All rights reserved. The Mitel word and logo are trademarks of Mitel Networks Corporation. Any reference to third-party trademarks is for reference only and Mitel makes no representation of ownership of...