Glass Replacement - Door; Glass Replacement - Side Window - Quadra-Fire 5100I-GD-B User Manual

C. Glass Replacement - Door Assembly
• Frequency: As needed
By: Homeowner / Qualified service technician
•
Task: See the following instructions.
•
Ensure that the fire is out and the appliance is cool
1.
to the touch.
. Protect a table or counter top with padding or
towels.
. Remove the door with the broken glass by lifting the
door up and off of the hinges.
4. Lay door face down on a table or counter making sure
the handle hangs over the edge so the door lays flat,
on a soft surface.
5. Remove the screws from each glass retainer and
remove the glass. (If screws are difficult to remove,
soak with penetrating oil first).
6. Center the new glass with edges evenly overlapping
the opening in the door, (i.e. same space top and
bottom, left and right sides).
7. Replace the glass retainers. Be careful not to cross
thread the screws.
8. Tighten each retainer just a few turns until each is
secured. Check again for centering of glass in door
frame. Continue to tighten each retainer alternately,
a few turns at a time, until the glass is secure. DO
NOT OVERTIGHTEN.
9. Replace the door on the appliance.
Quadra-Fire stoves are equipped with ceramic super heat-
resistant glass, which can only be broken by impact or
misuse. Do not slam stove door or impact the glass. When
closing door, make sure that logs do not protrude against the
glass. Inspect glass regularly. If you find a crack or break,
immediately put the fire out and return the door to your dealer
for replacement of glass before further use.
WARNING
Handle glass with care.
• Inspect the gasket to ensure it is
Glass
undamaged.
Assembly
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
& door assembly removed.
• Do NOT operate with glass cracked, broken or
scratched.
WARNING
Fire or Injury Risk
• Use only glass specified in manual.
• DO NOT REPLACE with any other material.
April 21, 2010
5100-I ACT WOOD INSERT
438-0380E
D. Glass Replacement - Side Window
• Frequency: As needed
By: Homeowner / Qualified service technician
•
Task: See the following instructions.
•
1. Open door and remove vertical brick in the bay
window area.
. Reach inside firebox and loosen  hex bolts using a
/8 inch socket wrench holding the cast in place.
3. Only remove the 2 bolts, top and bottom on the side
closest to the firebox opening. Figure 33.1.
4. Open the side of the window where the bolts have
been removed and slide out glass.
5. Slide new glass in making sure it slides into the cast
grooves.
6. Re-assemble in reverse order. Do not overtighten
bolts.
Slide Window In / Out
Loosen
bolts
Figure 33.1
R
Remove
bolts
Page