List Of Functions & Features - QSC CM16a Hardware Manual

Section 1:
Introduction- List of Functions & Features
FUNCTIONAL LISTING, BLOCK DIAGRAM & DETAILED DESCRIPTIONS
The CM16a performs control and monitoring of amplifiers remotely. Below is a listing of the functions that are available for the supported
QSC amplifiers. The following two pages (Block Diagram part 1 & 2) graphically illustrate the main functions of the CM16a. Following the
diagram is a section giving detailed explanations on each functional block that will aid in the use of the CM16a. Note that not all features
may be supported by the current revision level of software (consult software documentation for supported feature set). Where applicable,
functions are available on each individual channel.
CONTROL FUNCTIONS
Amplifier: Power (Standby/Operate Control)
CM16a:
MONITOR FUNCTIONS
Amplifier: Power Status
CM16a
SPECIAL FEATURES
DAC (digital-to-analog converter) that can be used for generating test signals & the playback of paging messages
RS-232 Port for setting of network address information
TFTP upgradeable firmware
8
Input Sensitivity Select
Signal Level Control
Signal Polarity Select
Contact Closure Output (switching of internal relay for control of external device)
Paralleling within DataPort Pair
Amplifier Model
Load Monitor (impedance)
Output Voltage
Output Power (real)
Headroom
Output Short
Output Level Meter
Input Level Meter
Audio Monitor Module (4 channel mono. mixer)
External Event Sensing (a logic-level or switch input)
Input Source Select (Normal/Page)
Signal Mute
Paging Control (with customizable routing)
Amplifier Gain
Bridge Mode
Protection Status
Output Current
Heat Sink Temperature (with Over-Temp.)
Clipping Detect
Output Open
Output Level Meter