Snmp Trap - Delta InsightPower SNMP IPv6 User Manual

SNMP Trap

SNMP Trap alerts users to event occurrences. To enable SNMP Trap, add Target
IP addresses to the list. Specify the community string, port, trap type and event
level, then click Add. Click on an entry to update settings or remove it from the
list.
NOTE
SNMPv1, SNMPv2c and SNMPv3 Traps are supported. If the SNMPv3
Trap is enabled, the user names must be specified in SNMPv3 USM.
The target IP addresses receive event notifications based on the event
levels you specified. Three event levels are shown as follows:
Information : All event notifications are sent to the target address.
z
z
Warning : Warning and alarm event notifications are sent to the tar-
z
z
get address.
Alarm : Only alarm event notifications are sent to the target address.
z
z
Click Event Level on the left panel to change event levels for individual
events.
InsightPower SNMP IPv6 for PDC
http://192.168.1.100/
4 0