Removing The Plastic Strip From The Remote Control; Replacing The Battery In The Remote Control - Hitachi AXM1205E Instruction Manual

Removing the Plastic Strip from the Remote Control

Remove the protective plastic strip from
the battery compartment if the battery is
being used for the first time. It is located at
the bottom of the remote control.

Replacing the Battery in the Remote Control

1. Remove the screw from the back
of the remote control using a
screw driver (not supplied).
2. Slide the battery compartment out
of the remote control and insert a
new battery (CR2025). Make sure
the '+' sign is facing up.
3. Slide the battery compartment
back into the remote control.
Replace the screw using a screw
driver (not supplied).
Handling the Remote Control
• Do not drop the remote control.
• Do not allow anything to impact the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the battery from the remote control when not in use for a long period of time,
as corrosion or battery leakage may occur and result in physical injury, and/or property
damage, and/or fire.
GB
15