Operation; Turning The Transceiver On And Off; Supply Voltage Display - Yaesu FT-818ND Operating Manual

Operation

Turning the Transceiver On and Off

1. To turn the transceiver on, press and hold in the
switch for one second.
2. To turn the transceiver off, again press and hold
in the switch for one second.
The one-second delay helps you avoid acci-
dental switching on (or off) of DC power.
When you turn on the transceiver, the DC supply voltage is indi-
cated in the upper left corner of the LCD for two seconds. After
this interval, the display will resume its normal indication of the
operating mode (VFOa, VFOb, or Memory Channel Number).
To view the supply voltage at any time during operation:
1. Press the key momentarily, then rotate the
Row 11* [ CHG, VLT, DSP ] on the display.
2. Press the
corner of the LCD.
3. To cancel the supply voltage display, again press the
Remember, the Operating Row Number does not appear on the display.
If you have not operated your FT-818 within the past week, we recommend that you
plug in the Battery Charger, and perform a 10 hour (use for PA-48B/C/U ) charge cy-
cle, to ensure that the SBR-32MH is ready for operation when you are.
16

Supply Voltage Display

( VLT ) key momentarily to display the supply voltage in the upper right
HOME
E
CLAR
A B C
knob to select Operating Function
( VLT ) key.
PWR
F
V
M
LOCK
PWR
SQL/RF