Menu Operation - Yaesu FT-818ND Operating Manual

Menu Operation

The Menu System allows you to customize a wide variety of transceiver performance
aspects and operating characteristics. Once you have gone through the various Menu
customization procedures initially, you will find that you will not have to resort to them fre-
quently during everyday operation.
Menu Operation
1. Press and hold in the
for the Menu Item will appear in the display.
2. Rotate the
3. When you have chosen the desired Menu Item
number, rotate the
value or condition for the Menu Item.
4. When you have made your selection, press and
hold in the key for one second to save the
new setting and exit to the normal operation.
 In step (3) above, if you press the
momentarily, it will reset the setting of thatMenu Item to its factory-default value.
 In step (4) above, if you press the
operation without saving the new setting.
Menu Item
Activate/deactivate the Automatic Repeater Shift
01 144 ARS
when operating on the 144 MHz band
Activate/deactivate the Automatic Repeater Shift
02 430 ARS
when operating on the 430 MHz band
Adjust the audio input level from the TNC
03 9600 MIC
during 9600 bps Packet operation
Enabling/disabling the
04 AM&FM DL
modes
05 AM MIC Adjust the microphone gain level for the AM mode
Select the tuning steps for the
06 AM STEP
mode
Select the antenna connector to be used on each oper-
07 ANTENNA
ating band (HF/50/144/430 MHz)
Select the Auto Power Off time (time before power goes
08 APO TIME
off)
09 ARTS BEEP Select the ARTS beep mode
10 BACKLIGHT Select the LCD lamp mode
11 BATT-CHG Select the battery charging time
12 BEEP FREQ Select the beep frequency
13 BEEP VOL Select the beep volume
14 CAT RATE Set the transceiver's circuitry for the CAT baud rate
15 COLOR Select the illumination color for the LCD illumination
16 CONTRAST Setting of the display contrast level
Set the receiver recovery time during pseudo-VOX CW
17 CW DELAY
semi-break-in operation
Enables/disables the CW identifier during ARTS
18 CW ID
operation
19 CW PADDLE Select the keyer paddle's wiring configuration
52
key for one second. The Menu Item number and a brief title
knob to select the Menu Item you wish to work on.
knob to change the
Function
HOME
HOME
E
CLAR
SEL
key
key momantarily, you will exit to normal
knob on the AM and FM
knob on the AM
F
F
A B C
C
DIAL
Available Values
OFF/ON
OFF/ON
0 ~ 100
ENABLE/DISABLE
0 ~ 100
2.5/5/9/10/12.5/25kHz
FRONT/REAR
OFF/1h ~ 6h
OFF/RANGE/ALL
OFF/ON/AUTO
6/8/10 h (hours)
440/880 Hz
0 ~ 100
4800/9600/38400 bps
COLOR1 (Blue)/
COLOR2 (Amber)/
COLOR3 (Violet)
1 ~ 12
10 ~ 500 msec
OFF/ON
NORMAL/REVERSE
V
M
LOCK
PWR
SQL/RF
Default
 1
 1
50
DISABLE
50
 1
 1
OFF
RANGE
AUTO
10
880 Hz
50
4800 bps
COLOR1
5
250 msec
OFF
NORMAL