Audiovox Car Security System APS-610 Installation Manual page 2

Fourth Press and release the valet switch
Press transmitter Lock button to change
Press transmitter Lock button to change
Press transmitter Lock button to change
Fifth Press and release the valet switch
Press transmitter Lock button to change
Sixth Press and release the valet switch
Press transmitter Lock button to change
Seventh Press and release the valet switch
Press transmitter Lock button to change
Eighth Press and release the valet switch
Press transmitter Lock button to change
Press transmitter lock button to change
Ninth Press and release the valet switch
Press transmitter Lock button to change
Press transmitter Lock button to change
Tenth Press and release the valet switch
Press transmitter Lock button to change
Eleventh Press and release the valet switch
Press transmitter Lock button to change
Twelfth Press and release the valet switch
Press transmitter Lock button to change
Press and release the valet switch
Turn ignition key off
Note: Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps,
or the programming will be terminated.
INSTALLATION OF MAJOR COMPONENTS
Note: This system allows the transmitter to be programmed for single button lock/unlock or separate
button lock/unlock. The receiver is set up as follows:
Channel #1
Channel #2
Channel #3
Channel #4
Channel #5
During the program routine, if a transmitter button is programmed into receiver channel 2, then the unit will
always have separate lock/unlock from that transmitter.
or
or
or
or
or
or
or
or
or
= Lock/Unlock/Unlock 2 &Panic
= If Programmed, Unlock/Unlock 2 & Panic
= Channel 3 & Alternate Channel 3
= Channel 4 Output
= Channel 5 Output (If so Equipped)
3 chirps = headlight output when arming and disarming
4 chirps = headlight output off
1 chirp = headlight output when arming
2 chirps = headlight output when disarming
2 chirps = active locks
1 chirp = passive locks
2 chirps = active arming
1 chirp = passive arming
2 chirps = hardwire
1 chirp = voltage sense
1 chirp = siren and horn output
2 chirps = siren output only
3 chirps = horn output only
2 chirps = horn chirp output 16mS
3 chirps = horn chirp output 30mS
1 chirp = horn chirp output 10 mS
2 chirps = valet switch override operation
1 chirp = custom code override operation
2 chirps = 2 step unlock off
1 chirp = 2 step unlock on
2 chirps = chirp delete from transmitter inactive
1 chirp = chirp delete from transmitter active
Exit program mode
Exit program mode
Page 2