Audiovox car security system installation manual (14 pages)
Summary of Contents for Audiovox Prestige 128-8601
Page 1
Model APS-45N Owner's Manual 4 Button Remote Keyless Entry System With Two Auxiliary Outputs FEATURES: 2 Four Button, RF Transmitters Four Channel Code Learning Receiver Remote Panic In All Modes Built-In Parking Light Output LED Status Indicator ...
Page 2
Your Keyless Entry System has many features and available options some of which must be selected at time of installation. For your reference, the list on the back page of this manual shows what features and options have been installed with this particular sys- tem.
Note: If the passive arming mode was selected at time of installation, the dash mounted LED will start flashing rapidly indicating that the system is rearming. Opening any door will suspend the automatic arming. OPTIONAL ACCESS GUARD ( Two Step Unlock ) If the optional 2-step unlock feature was installed, then only the driver's door will unlock after the first press of the unlock button.
Page 4
To disengage the panic feature before the 30 seconds are up, press and hold either the lock or unlock button of your keychain transmitter for 3 seconds or press the option button momentarily. The doors can be unlocked or locked while in "panic" mode by momentarily pressing the lock or unlock button respectively.
PROGRAMMING TRANSMITTERS: At times it may become necessary to program replacement or additional transmitters for use with your system. To do this: 1) With the system unlocked or disarmed, turn the ignition key to the on position. 2) Press and release the Program/Override push-button switch three times The unit will flash the parking lights and or beep the horn once to indicate that the system is in the transmitter program mode.
DELETING TRANSMITTERS FROM YOUR SYSTEM: It may be necessary to delete a lost transmitter or to reprioritize a transmitter that is programmed to your system. To remove a transmitter that has been programmed in your system: 1) Enter the transmitter program mode of channel 1 as indicated above. 2) Press and hold any transmitter button that has not been programmed into channel 1 until you hear a chirp, then release and immediately press the same button a second time until you hear a long chirp followed by a short chirp.
Page 7
Simply dial 1 - 800 - 645 - 4994, and follow the instructions from the operator interface. 9) Mail this form along with your payment to: Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y., 11788 Attn.: TRANSMITTER DEPARTMENT $65.00...