Solid-State Drive (Ssd) - HP EliteBook 850 G5 Notebook PC Maintenance And Service Manual

Solid-state drive (SSD)

Description
1 TB, PCIe, Gen3×4, NVMe, TLC
512 GB, PCIe, Gen3×4, Self-encrypting drive (SED), Opal 2, TLC
512 GB, SATA-3, FIPS-140–2, TLC
360 GB, PCIe Gen3×4, NVMe,TLC
256 GB, PCIe, Gen3x4, SS, NVMe, TLC
256 GB, PCIe, NVMe, value
256 GB, SATA-3, Opal 2, TLC
128 GB, SATA-3, TLC
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive by pulling it away from the connector (2).
NOTE:
Reverse this procedure to install the solid-state drive.
Bottom cover on page
M.2 solid-state drives are designed with notches to prevent incorrect insertion.
37).
Battery on page 50).
Component replacement procedures
Spare part number
L17246-001
L17250-001
L17249-001
L17252-001
L17247-001
L17248-001
L17254-001
L17245-001
39