Cisco ASR 900 Series Configuration Manual page 98

Configuring protect node for POS MR-APS
Command or Action
Step 13
exit
Example:
Router(config-ctrlr-sts1)# exit
Step 14 controller SONET slot/bay/port
Example:
Router(config)# controller SONET 0/5/2
Step 15 Shutdown
Example:
Router(config)# Shutdown
Step 16 aps group group_id
Example:
Router(config-controller)# aps group 1
Step 17 aps protect 1 remote loopback ip
Example:
Router(config-controller)# aps protect 1
192.168.1.1
Step 18 aps interchasis group interchasis group-id
Example:
Router(config-controller)# aps interchasis
group 1
Step 19
no shut
Example:
Router(config-controller)# no shut
Step 20
exit
Example:
Router(config-controller)# exit
Step 21 interface POS slot/bay/port
Example:
Router(config)# interface POS 0/5/2
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
90
Configuring Multi Router Automatic Protection Switching
Purpose
Exits from the STS configuration mode.
Selects and configures a SONET controller and enters
controller configuration mode.
Shut down the controller before APS configuration.
Configures the APS group for POS.
Enable the protect node.
Enable the inter chasis.
Unshut the controller.
Ends the controller session and returns to the configuration
mode.
Configures a serial interface and enters the interface
configuration mode
• slot—Chassis slot number, which is always 0.
• bay—Card interface bay number in a slot. The range
is from 0 to 5.
• port—Port or interface number. The range can be
0-3.