Cisco ASR 900 Series Configuration Manual page 30

Configuring Structure-Agnostic TDM over Packet (SAToP)
Command or Action
Step 5
interface cem slot/subslot
Example:
Router(config)# interface CEM 0/4
Example:
Router(config-if)# no ip address
Example:
Router(config-if)# cem 4
Step 6 xconnect ip_address encapsulation mpls
Example:
Router(config-if)# xconnect 10.10.2.204
encapsulation mpls
Step 7
exit
Example:
Router(config)# exit
What to Do Next
Note When creating IP routes for a pseudowire configuration, we recommend that you build a route from the
cross-connect address (LDP router-id or loopback address) to the next hop IP address, such as ip route
10.10.10.2 255.255.255.254 10.2.3.4.
Time Division Multiplexing Configuration Guide, Cisco IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
22
Purpose
Defines a CEM group.
Binds an attachment circuit to the CEM interface to create
a pseudowire. This example creates a pseudowire by
binding the CEM circuit 304 to the remote peer
10.10.2.204.
Exits configuration mode.
Configuring Pseudowire