Advertisement
Step Three
Insert Centre Rail (5) into the brackets in the centre of the Headboard (1) and Footboard (2).
Push down fully and secure in place using M6 x 25mm bolt (A) and tighten bolt with Allen Key M4 (E).
You can now tighten the bolts at the Side Rails from the previous step (Step Two) so all fastenings are
now tightened.
g. 3
Centre Rail
A
E
M4 x1
M6 x 25mm x2
Step Four
Take two Slats (4) ensuring the curved side is facing up and join them together with a Centre Plastic
Cap (C) then place a Side Plastic Cap (D) on the other end of the Slats. Fix the Slat to the bed by first
inserting the Side Plastic Cap (D) into the holes in the Side Rail (3) then Centre Plastic Cap (C) into the
holes in the Centre Rail (5).
g. 5
Slat
Centre Plastic Cap
Slat
Centre Rail
g. 2
M6 x 25mm
g. 4
Slat
Side Plastic Cap
Side Rail
4/6
AFTER INSERTING CENTRE RAIL,
TIGHTEN ALL FIXINGS FULLY
INCLUDING BOLTS AT SIDE
RAILS (FROM STEP TWO)
4
Bent Slat (30pcs)
C
Centre Plastic Cap (15 pcs)
D
Side Plastic Cap (30 pcs)
Advertisement
