Advertisement
Quick Links
John Lewis
SINGLE
Pre-assembly Preparation
Please ensure instructions are read in full before attempting to assemble this product
Necessary Tools
Please check the pack contents before attempting to assemble this product. A full checklist of
components is given in this leaflet.If any components are missing, please contact the John Lewis Helpline.
Heavy
This product is
WHEN LIFTING
This product takes approximately
The fittings pack contains
CHILDREN
.
Read this leaflet in full before commencing assembly.
If you require any additional information or have any issues with this product please call the John Lewis
Helpline on 01244 - 689949 or e-mail: mail@fwgroup-uk.com
Apollo Bedstead
, it should be assembled as near as possible to the point of use.
to avoid personal injury and (or) damage to the product.
40 MINUTES
SMALL PARTS
For product support or spare parts
please call the John Lewis Helpline;
Tel: 01244 - 689949
e-mail:mail@fwgroup-uk.com
to assemble with
KEPT AWAY FROM YOUNG
which should be
Stock number: 803/41301
TAKE CARE
2 PEOPLE
.
Advertisement
Related Manuals for John Lewis Apollo 803/41301
Summary of Contents for John Lewis Apollo 803/41301
- Page 1 The fittings pack contains which should be CHILDREN Read this leaflet in full before commencing assembly. If you require any additional information or have any issues with this product please call the John Lewis Helpline on 01244 - 689949 or e-mail: mail@fwgroup-uk.com...
- Page 2 Fitting and parts checklist Wooden Slats Bolt 2 Bolt 8...
- Page 3 Step by step assembly instructions Step One Attach the Side Rails (3) to the Headboard (1) and Footboard (2) using Washer (A) and M6 x 25mm Bolt (C). Tighten using Allen Key (F) as shown in the diagram below. Repeat this for all 4 corners. Note: Please ensure the Side Rails (3) are assembled correctly, there is a label indicating the left and right hand side.
- Page 4 Step Three Starting at the head end, take a Wooden Slat (4) ensuring the curved side is facing up and place a Side Plastic Holder (E) onto each end of the Slat (4). Secure to the bed by pushing each end into the pre-drilled holes along the Side Rail (3) as shown in the diagram below.
- Page 5 This product complies with BS 1725:1998...