Philips SW175 Manual page 21

Problem
The appliance d
oes not shave as
well as it used to.
Water is leaking
from the bottom
of the appliance.
Possible cause
The temperature of
the shaver is too
high. In this case,
the shaver does not
work.
The shaving heads
are damaged or
worn.
Hairs or dirt
obstruct the shaving
heads.
During cleaning,
water may collect
between the inner
body and the outer
shell of the
appliance.
English
Solution
Let the shaver cool down.
As soon as the temperature
of the shaver has dropped
sufficiently, you can switch
on the shaver again.
Replace the shaving heads.
Clean the shaving heads in
the regular way or clean
them thoroughly.
To clean the shaving heads
thoroughly, remove the
shaving heads from the
shaving head holder one
by one (see 'Replacement').
Then separate the cutter
from its guard and rinse
each matching set under
the tap. After rinsing, place
the cutter back into its
corresponding guard.
Finally, put the shaving
heads back into the
shaving head holder (see
'Replacement').
This is normal and not
dangerous because all
electronics are enclosed in
a sealed power unit inside
the appliance.
21