Philips SW175 Manual page 17

1
2
2
1
1
2
Storage
4 Lift the retaining ring out of the shaving head
holder. Place aside in a safe place.
5 Remove the shaving heads and place new ones
in the shaving head holder.
Discard the used shaving heads immediately to
avoid mixing them with the new shaving heads.
Make sure the two wings of the new shaving
heads fit exactly into the recesses of the
shaving head.
6 Place the retaining ring back onto the shaving
head holder. To reattach the retaining ring, turn
it against the direction of the arrows indicated
in and on the retaining ring.
Make sure the retaining ring is fixed properly.
The four wings of the retaining ring have to be
located exactly under the recesses of the
shaving head holder.
7 Reattach the shaving head holder to the
shaving unit ('click').
If the shaving unit does not close smoothly,
check if you have positioned the shaving heads
properly and if the retaining rings are fixed
properly.
Put the protection cap on the shaver to prevent
damage.
Note: Always let the shaver air dry completely
before storing.
17
English