TO ADJUST DEPTH OF CUT
DISCONNECT TOOL FROM POWER SOURCE.
Loosen the depth adjusting knob (A)
Fig. 1, and raise or lower the saw
housing until the blade extends the
A
desired distance below the base. For
best results, the blade should barely
protrude through the workpiece. Firmly
tighten the knob to hold the saw in
position.
Fig. 1
TO ADJUST FOR BEVEL CUTS
DISCONNECT TOOL FROM POWER SOURCE.
Loosen the front (A) Fig. 2 and rear (B) Fig. 2 angle-adjusting knobs. Tilt the
saw housing until the desired graduation mark (C) lines up with the
indicating line (D) Fig. 3 on the depth adjusting bracket. Firmly tighten the
knobs to hold the saw in the selected position.
B
D
A
C
Fig. 3
Fig. 2
TO ATTACH THE BASE INSERT
The base insert is used to reduce chipping and splintering of the top fibers
of plywood and paneling when used in conjunction with a fine tooth blade.
When the base insert is used, it is not necessary to have the good or
finished side of the work down during the cutting operation.
NOTE: Do not use this insert when making bevel cuts.
11