Advertisement
KEY DIAGRAM
(INSERT YOUR PARTS DESCRIPTION DIAGRAM HERE AS ON YOUR
PAGE GIVEN)
ASSEMBLY
1. Thread the power cord through the opening in the base.
2. Insert the stand into the base and line the two up
3. Lead the power cord through the recess at the side of the base.
4. Remove the blade cap and guard lock nut from the motor shaft.
5. Fit the rear guard onto the location pins and secure the guard to the motor
body using the guard lock nut.
6. Push the blade onto the motor shaft by matching the slots on the base of the
blade with the shaft pin. Secure the blade with the blade cap.
7. The blade cap must be tightened by turning in an anti –clockwise direction.
Check that the blades rotate freely by turning with your hand.
8. Open the securing clip at the bottom of the front guard and loosen the clip
screw. Position the top clip on the uppermost part of the rear guard. Push
the top clip down and press the rim of the front guard onto the rear guard.
Close the bottom clip and tighten the screw.
OPERATING INSTRUCTIONS
SPEED SELECTION
There are 3 speed selections :
OFF
LOW
MEDIUM
HIGH
TILTING
Always ensure that the fan is switched off before changing any positions.
Hold the stand firmly with one hand, and move the guard gently up or down.
OSCILLATION
The oscillation feature enables a wider circulation of air flow due to the fan head
0
1
2
3
Advertisement
