Audio Technica ATW-1821 Owner's Manual page 11

Turning your Transmitter On & Off
To turn the transmitter on, press and hold the Power/Mute button until the power indicator lights
green, and the LCD window comes on (about 1-2 seconds). The operating frequency will show in
the window after the power-up sequence.
To turn the transmitter off, press and hold the Power/Mute button again, until the power indicator
and the LCD window are extinguished (about 1-2 seconds). The LCD window will show
"PWR.OFF" before shutdown.
How to Set Frequencies on your Transmitter
NOTE: Transmitter-Receiver pairs must be set to identical frequencies: Set Transmitter 1 to the
same frequency as Receiver Channel 1; Set Transmitter 2 to the same frequency as Receiver
Channel 2.
1. Turn transmitter on.
Press the Set button once and the small word "MENU" will appear above the frequency.
2.
Press the Set button again and the small flashing word "EDIT" will appear to the right of "MENU".
3.
Use the Up/Down arrows to change the transmitter frequency. Press either arrow for 25 kHz steps,
4.
or hold down either arrow for rapid cycling through the range. Frequencies "wrap around" when the
top or bottom of the band is reached. Select the exact frequency displayed on the receiver.
5. To activate this frequency selection, press and hold the Set button until the word "STORED"
appears in the transmitter's window. (If you do not wish to complete this selection, just press the
Set button once: the word "ESCAPE" will appear briefly in the window and the transmitter will return
to the Menu mode.)
6. When finished entering a frequency, press the Up arrow once to move to "QUIT". Then press the
Set button once to exit the menu. The word "MENU" in the transmitter window will go off, indicating
the return to normal operation.
How to Access & Use the Function Menu on your Transmitter
1. Turn transmitter on.
2. Press the Set button once; the small word "MENU" will appear above the frequency.
3. When in the Menu mode, use the Up and Down arrows to cycle through the following functions:
•
Frequency
•
RF Power
•
Audio Input Level
•
Power/Mute Locks
•
Input Select
•
Reset to Defaults
•
Quit (exit menu)
4. To make a change in the default setting:
Press Set button once;
Press Up or Down arrow until you reach desired setting;
Press and hold Set button until the word "Stored" appears in the LCD window.
(If you do not wish to complete this selection, just press the Set button once: the word
"ESCAPE" will appear briefly in the window and the transmitter will return to the Menu mode.)
Transmitter Functions
Function Menu
▲▼ Frequency
▲▼ RF Power
▲▼ Audio Input Level
▲▼ Power/Mute Locks
▲▼ Input Select**
▲▼ Reset to Defaults
▲▼ Quit
**on UniPak Transmitter only
RF Power Adjustments on your Transmitter
Default Setting Choices (Edit) ▲▼
Lowest in band 996 frequencies (25 kHz steps)
RF LOW RF LOW
+6 dB -6 dB 0 dB +6 dB +12 dB
NO. LOC NO. LOC ALL.LOC MUT.LOC. PWR.LOC
MIC MIC INST
LOAD (b) hold until: DEF (c) hold until: LOADED
PRESET
Press Set to exit
QUIT
RF HI
Wrap-around*
Yes
Yes
No
Yes
Yes
-
-