PIAGGIO Liberty 125ie Manual page 16

lock, provided that the safety system recognises the code transmitted by the key. If
the code is not recognised, turn the key first to "OFF" and then to "ON"; if the lock
cannot be disabled, try with the other key supplied (brown). If the engine cannot be
started, contact an Authorised Piaggio Service Centre, which is provided with the
electronic equipment required to detect and repair the system. The Immobilizer is also
activated by switching off the engine with the RUN OFF switch. This happens even if
the starter key is in «ON».
When additional keys are required, please note that data storage (up to 3 keys max.)
must be done on all keys, both new ones and existing ones. Take the key with the
brown grip and all the blue keys supplied to an Authorised Piaggio Service Cen-
tre. The codes of keys not submitted for the new programming procedure are deleted
from the memory. Any lost keys will therefore not be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
SHOULD THE VEHICLE CHANGE OWNER, IT IS ABSOLUTELY NECESSARY
THAT THE NEW OWNER GET POSSESSION OF THE KEY WITH THE BROWN
GRIP (AS WELL AS ALL OTHER KEYS).
Procedure start-brown key
Insert the brown key into the ignition switch (in the «OFF» position), turning it to the
«ON» position. After 1 - 3 seconds, turn the key to «OFF » again and pull it out.
16