Installation; Faucet Assembly/Installation - Westinghouse QL045 Owner's Manual

Installation

FAUCET ASSEMBLY/INSTALLATION

1 . Carefully take out all the parts of the faucet assembly (C) . The faucet
is pre-assembled, except for the sprayer head .
2 . Take the washer, gasket and retaining ring off of the faucet body .
3 . Place the faucet body carefully through the hole in the sink (B) . A
second person may be required to hold the body in place until the
faucet installation is complete .
4 . From underneath, slide the washer, gasket and retaining ring over
the end of the copper pipe and up to the exposed threaded section of
the faucet . Tighten the retaining ring by hand until it is snug . Using a
wrench or pliers, tighten the assembly .
5 . Gently tighten the two screws on the retaining ring .
Do not over tighten .
6 . Screw the sprayer head onto the gooseneck pipe .
7 . Connect the water supply lines (not supplied) to the faucet .
Faucet body
Gasket
Retaining ring
Screws
6
Gooseneck pipe
Sprayer
head
Faucet handle
Washer
Threaded section