Care And Cleaning; Utility Sink; Cabinet - Westinghouse QL045 Owner's Manual

Care and Cleaning

UTILITY SINK

Do
- After use, always rinse your sink with tap water to
dilute and remove deposits .
- Towel dry after use whenever possible to prevent
water spots . Should water spots occur, clean with
a mild solution of vinegar and water followed by a
thorough rinse .
- Use liquid soap, a general household cleaner, or a weak
solution of vinegar and water for regular cleaning .
- Only use plastic scouring pads recommended for use
in stainless steel sinks, and only use them in the bowl
of the sink. Scrub in the direction of the satin finish lines.
Do
- Do not allow any food, detergent, soap or grease to dry
or sit for extended periods of time on the surface of the
sink .
- Never use abrasive cleaning products, as they will dull
and scratch the finish.
- Do not use scouting pads on the deck, as they will dull
the mirror finish.
- Never use steel wool pads, as they will leave iron
particles on the sink, which will cause corrosion .
- Never leave steel or cast iron pans in your sink for
extended periods of time, as this can cause corrosion .
Your sink is manufactured with the highest grade stainless steel and will provide you many years of enjoyment with the proper care .
SCRATCH, SPOT, AND BLEMISH REMOVAL AND SURFACE RESTORATION:
Little rust spots and blemishes that periodically appear in the sink are typically the result of the steel interacting with the chemicals
found in the vast spectrum of substances that sinks are commonly exposed to . They may also get transferred from other objects
placed or left in the sink . Scratches are the result of regular wear and tear .
To remove scratches, spots, and blemishes from the sink, rub them with a non-metallic scouring pad (e .g . Scotch-Brite
with a mild abrasive cleaner (e .g . Vim
When finished, rinse the sink with water and dry it with a towel to allow the sink to form a protective outer layer. This procedure can
also be used to renew all of the surfaces of the sink .
® or Barkeeper's Friend ® ) . Always rub the surfaces in the direction of the grain of the steel .
11
Please contact customer.service@conglomkb.com or 1-877-333-0098 for further assistance .

CABINET

Do
- Remove dust and dry dirt with a soft, damp cloth .
- Clean grease, oil, paint and ink stains with isopropyl
(rubbing alcohol) . Immediately rinse with water after
stain removal .
Do not
- Do not allow your cabinet surface to come into contact
with products such as acetone (nail polish remover),
nail polish, dry cleaning solution, lacquer thinners,
gasoline, pine oil, etc .
- Use caution when using sharp instruments that may
fall and scratch the surface .
® ) combined
CONGLOMKB .COM