Pioneer DVR-LX60D Operating Instructions Manual page 125

Additional information
Problem
No picture
The picture from the
external input is
distorted
The picture is distorted • Change the Input Line System setting (page 119). (You can also
Screen is stretched
vertically or
horizontally
No sound or sound is
distorted
Audio/subtitle
language cannot be
changed
Remedy
• Check that everything is connected properly (page 14).
• Check that the connected TV and/or the AV amp/receiver is set to the
correct input.
• The recorder may be set to progressive scan with an incompatible
TV. Reset to interlace by pressing and holding the front panel  (Stop)
button then pressing  OPEN/CLOSE.
• If you are using an indoor antenna that requires power, make sure that
Aerial Power in the Initial Setup menu is set to On or Auto (page 108).
• If the aerial/antenna is not connected properly, or if it is shorted, the
Aerial Power setting will revert to Off automatically. Check the aerial
connection and try making the setting again.
• When the HDMI signal is output, no video is output from the
COMPONENT VIDEO OUT.
• If the channel selected on this unit is an HD broadcast, it cannot be
displayed.
• If the video signal from the external component is copy-protected,
you cannot connect via this recorder. Connect the component directly
to your TV.
change it by pressing the  (Stop) button and INPUT SELECT on the
front panel simultaneously with the recorder stopped.)
• Make sure that the TV Screen Size setting (page 115) is correct for
the kind of TV you have (see also page 134).
• If you have a widescreen TV, check its aspect ratio settings.
• This recorder's input switches into wide mode automatically
according to the input signal. When the unit connected is not
compatible with VIDEO ID-1 (widescreen signalling), set the
connected component to output 4:3 aspect ratio (standard) video.
• Make sure that the amp/receiver or TV is set to the correct input and
the volume turned up.
• There is no sound when the picture is paused, or during scanning or
slow motion play. Press  PLAY to resume regular playback.
• DTS discs can only be played if this recorder is connected to a DTS
decoder or DTS compatible amp/receiver. If you have connected a
suitable decoder, also make sure that the Initial Setup > Audio Out
> DTS Out setting is On.
• Some 96 kHz discs do not output audio through the digital jack. In
this case, switch the input of your amp/receiver to analog.
• Check the audio cable connections (page 14).
• If the sound is distorted, try cleaning the cable plugs.
Note that audio and subtitle languages cannot be changed
•
during the recording of a digital broadcast.
• You can only use the audio track and subtitles for the language that
were selected at the time of recording a digital broadcast. The audio
track and subtitles cannot be changed to other languages.
16
125
En