Installing The Sfp+ Modules In The Supervisor Pic - Cisco cBR Hardware Installation Manual

Installing the Supervisor in the Cisco cBR Chassis
•

Installing the SFP+ Modules in the Supervisor PIC

Before You Begin
Do not install or remove the SFP+ module with fiber-optic cables still attached to it. Doing so may damage
Caution
cables, cable connectors, or the optical interfaces and may interfere with the SFP+ module latching properly
into its socket connector. Disconnect all cables before removing or installing an SFP transceiver module.
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
• You must use the supported SFP+ modules. The following SFP+ modules are supported on the Supervisor
Required Tools and Equipment
• ESD-preventive wrist strap
• SFP+ module
Step 1 Remove the SFP+ module from its protective packaging.
Route the Supervisor PIC cables through the Supervisor PIC cable management bracket and
chassis-mounted fiber/cable routing
connected to the chassis.
PIC:
◦ SFP-10G-SR
◦ SFP-10G-LR
◦ SFP-10G-ER
◦ SFP-10G-ZR
◦ SFP-10G-LRM
Installing the SFP+ Modules in the Supervisor PIC
guide.
Cisco Converged Broadband Routers Hardware Installation Guide
43