Notes On Handling - JVC RD-HA3B Instructions Manual

Suitable Locations for the System
• Install the System in a location with adequate ventilation to
prevent internal heat build-up in the System.
DO NOT install the System in a location near
heat sources, or in a place subject to direct
sunlight, excessive dust or vibration.
• Install in a place which is level, dry and neither too hot nor
too cold—between 5°C and 35°C.
• Leave sufficient distance between the System and the TV.
Precautions
Power sources
• When unplugging the System from the wall outlet, always
pull on the plug, not the AC power cord.
• If you are not going to operate the System for an extended
period of time, unplug the AC power cord from the wall
outlet.
DO NOT handle the AC power cord with wet
hands.
Internal heat
• Make sure there is good ventilation around the System.
Poor ventilation could cause the System to overheat and
become damaged.
DO NOT block the ventilation openings or
holes. If they are blocked by a newspaper or
cloth, etc., the heat may not be able to get out.
Others
• Should any metallic object or liquid fall into the System,
unplug the AC power cord and consult your dealer before
operating any further.
DO NOT disassemble the System since there
are no user serviceable parts inside.
If anything goes wrong, unplug the AC power cord and
consult your dealer.
Condensation
Moisture may condense on the lenses inside the System in
the following cases:
• After starting to heat the room
• In a damp room
• If the System is brought directly from a cold place into a
warm place.
Should this occur, the System may malfunction. In this case,
leave the System turned on for a few hours until the moisture
evaporates, unplug the AC power cord, then plug it in again.

Notes on Handling

Maintenance
To get the best performance out of the System, keep your
discs and the mechanism clean.
Cleaning the System
• Stains should be wiped off with a soft cloth. If the System
is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean
with a dry cloth.
• Since the System may deteriorate in quality, become
damaged or get its paint peeled off, be careful about the
following:
– DO NOT wipe it with a hard cloth.
– DO NOT wipe it forcefully.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substances such as
– DO NOT allow any rubber or plastic to remain in contact
Handling discs
• Remove the disc from its case by holding it at the edge
while pressing the center hole lightly.
• Do not touch the shiny surface of the disc, or bend the disc.
• Put the disc back in its case after use to prevent warping.
• Be careful not to scratch the surface of the disc when
placing it back in its case.
• Avoid exposure to direct sunlight, extreme temperature,
and moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center
to edge.
insecticides to it.
for a long time.
18