Lamp; Lamp Operation - 3M X26i Safety Manual

3M™ Digital Projector X21i/X26i

Lamp Operation:

The following symptoms may indicate a lamp in need of replacement:
• LAMP indicator lights up red.
• To reduce the risk associated with environmental contamination due to
mercury in the projection lamp:
- Dispose of lamp cartridge in accordance with applicable federal, state and local regulations.
- The lamp in this product contains mercury. Dispose of projection lamp in a manner
that is consistent with your local hazardous waste regulations for mercury.
- For recycling and disposal information, contact your respective governmental
agencies.
In U.S., contact 1-800-328-1371 (3M US) or the Electronic Industries Alliance at
www.lamprecycle.org
In Canada, contact 1-800-364-3577 (3M Canada)
Display Lamp Operation Hours
To determine the lamp operation hours, follow these steps:
1. While the projector is running, press the MENU button on the remote control.
Choose the "OPTION" using the ▼ button, and press the ► button or the ENTER button.
Choose the "LAMP TIME" using the ▼ button.
2. The operating time of the lamp will be displayed.
The lamp time is the time counted after the last resetting.
For an accurate indication of elapsed lamp time, only reset the lamp time to zero when the
lamp is replaced.
Reset Lamp Hours
(1) Press the MENU button to display the EASY MENU.
(2) Point at the "Go To Advance Menu ..." in the menu using ▼/▲ button, then press the
► button.
(3) Point at the "OPTION" in the left column of the menu using ▼/▲ button, then press
the ► button.
(4) Point at the "LAMP TIME" using ▼/▲ button, then press the ► button. A dialog will
appear.
(5) Press the ► button to select "RESET" on the dialog. This resets the lamp time.
© 3M 2012. All rights reserved.

Lamp

WARNING
√ Note
Product Warranty and Safety Guide
13