Table of Contents
Advertisement
To Activate Remote-Controlled Valet
1 . Press the A and s buttons at the same time for 1-2 seconds.
2 . The parking lights will flash 4 times, and the LED will turn on solid red.
To Deactivate Remote-Controlled Valet
1 . Press the A and s buttons at the same time for 1-2 seconds.
2 . The parking lights will flash 3 times and the LED will turn off.
LED System Status Indicator
The LED on your vehicle dashboard or center console will inform you of the
system status.
LED
Off
On solid
Slow flash
Flashing in cycles
Rapid flash
Remote-Controlled Trunk Release Capability
If you had the optional Trunk Release feature installed, simply press the
dbutton for 1-2 seconds to activate your vehicle electronic trunk release.
The trunk will "pop" open. This feature will only work if your system is
disarmed (may require an optional relay).
Remote-Controlled Accessory Outputs
These outputs allow you to add optional remote-controlled accessories to your
system such as a window roll-up, garage door opener or fuel door release. To
activate your optional accessories, see the "Programming Table for Remote
Controls" on page 16.
2
Zone
™ Impact Sensor
2
The Zone
Impact Sensor has two individual vibration/impact sensing zones.
Zone #1:
If a less threatening vibration or impact is detected, the siren will issue 2
warn-away chirps. A second violation will also issue 2 warn-away chirps. If
within 45 seconds a third violation is detected, the sensor will automatically
trigger the alarm. The siren will sound and the lights will flash.
AviStart 6501 Owner's Manual - 0999
Status
System is disarmed
In Protected Valet Mode
System is armed
See "Specific Zone Intrusion Identification" on page 8
Passive arming
7
Advertisement
Table of Contents
