Water Drainage; Electrical Connection - Bosch WIA24201GC Instruction Manual And Installation Instructions

Water drainage

Drainage into a siphon

Electrical connection

Fitting the door hinges
to the washing machine
– Do not kink the drain hose or pull it lengthways.
– Height difference between the installation surface and the drain:
max. 90 cm, min. 50 cm.
Secure the connection point with a 24-40 mm hose clamp.
The washing machine must only be connected to an alternating current
using a properly installed earthed socket.
Only use earth-leakage circuit breakers with the following symbol:
The power supply and voltage information indicated on the washing
machine (rating plate) must be the same.
The connected load and fuse required are specified on the rating plate.
Make sure that:
– the mains plug fits the socket.
– the cable cross-section is adequate.
– the earthing system is properly installed.
– the appliance is not standing on the mains cable.
– the mains plug is accessible at all times.
Changes to the mains cable may only be carried out by a qualified
electrician.
Do not use multiple plugs/adapters or extension cables.
Mains plug:
– do not plug in or unplug the mains plug when your hands are wet.
– pull the appliance plug out of the socket at the plug only, not by the
cable.
– never unplug the plug during operation.
Once the washing machine has been installed in a kitchen unit, it can be
concealed using a door. If you wish to do this, you must fit the supplied
hinges to the washing machine.
27