Unable To Complete; Adaptiq® Audio Calibration - Bose ACOUSTIMASS Owner's Manual

T R O U B L E S H O O T I N G

Unable to complete

ADAPTiQ
Listen to the voice prompts for the following error messages:
Error Problem
message
1 The microphone on the
ADAPTiQ headset cannot
detect sound.
2 The room is too loud.
3 The ADAPTiQ headset is
too close to the speakers.
4 The listening locations are
too similar.
5 The ADAPTiQ headset
cannot take measurements
due to movement.
After correcting your problem, you must re-run ADAPTiQ audio calibration
(see page 12).
If you hear a different error message, contact Bose customer service for further
instructions.
2 0 - E N G L I S H
audio calibration
®
What to do
• Secure all cables.
• Disconnect the ADAPTiQ headset cable and
reconnect it firmly into the soundbar's ADAPTiQ
connector.
• Ensure the microphone opening on the top of
ADAPTiQ headset is not blocked.
• Your ADAPTiQ headset may be damaged. Call
Bose customer service for replacement parts.
Re-run ADAPTiQ audio calibration when the room
is quiet.
Move the ADAPTiQ headset farther away from the
speakers.
Move 1 – 2 ft. (.3 – .6 m) away from your previous
listening location.
Hold your head still.