Care And Cleaning - Thermador UCV30 Use And Care Manual

The efficiency of the Cook'n'Vent
tion system depends on the cleanliness of the intake
and filters. The frequency of cleaning depends on the
amount and type of cooking.
• Do not use the ventilating system without the fil-
ters in place or with grease-laden filters or surfaces.
To Remove and Clean Filters
1. Intake must be in the raised position to clean.
2. Turn Off the blower.
3. Remove filters by pushing top of filters with thumbs
until they release from frame. Begin by removing
center filter(s), then remove outside filters.
Care and Cleaning Tip
• Always use the mildest cleaner that will do the job. Use clean, soft cloths, sponges or paper towels.
• Rub stainless steel finishes in the direction of the grain. Wipe area dry to avoid water marks.
• After cleaning, place filters in their proper positions before using the Cook'n'Vent
The cleaners recommended in the Care and Cleaning Table (pg. 6) indicate a type and do not
constitute an endorsement. Use all products according to package directions.
Order of Filter Removal
2 1 2
30" and 36" UCV Filters

CARE AND CLEANING

® downdraft ventila-
2 1 1 2
45" UCV Filters
4. Wash filters with soap and warm water, or in a dish-
washer
5. Wipe up any accumulated grease or food on the
Intake. Use a general household degreaser spray or
cleaner. Rinse and dry.
To Re-Assemble the Filters
1. Insert bottom edge of filter into ledge at bottom of
frame intake.
2. Push top portion of filter into top frame of intake
until it snaps into place.
3. Do the same for each filter. Begin with outside fil-
ters, then center filters.
Order of Filter Replacement
1 2 1
30" and 36" UCV Filters
PAGE 5
CAUTION:
Do not touch filters
until they have suf-
ficiently cooled off.
® .
1 2 2 1
45" UCV Filters