Convection Adjustments; Air Intake Adjustments; Stove Maintenance; Maintenance Safety - Drolet ECO-55 Operation Manual

NOTICE
To avoid premature wear of the components, it is
recommended to use the «Pilot ON» mode during
the coldest months and the «Pilot AUTO» mode
during the warmest months.

5.7 CONVECTION ADJUSTMENTS

Each intensity level has been programmed with an
optimum convection speed. However, it is possible
to increase the convection air speed by pressing the
«AUX» button. All intensity levels can be increased at
the exception of the intensity level 6, which is already
at its maximum speed.

5.8 AIR INTAKE ADJUSTMENTS

It is possible to adjust the amount of combustion air
entering the stove.
Using the stove to the lowest setting will reduce
missed ignition, will ignite pellets faster and will
reduce the blackening of the window, when using
high quality pellets. If you should find one bag of
pellets harder to ignite and to burn, opening the air
control will help.
To open or close the manual air control, open the
right decorative panel and locate the air intake. Push
down the tab and slide upwards to decrease the air
supply and downwards to increase the air supply.
Page 8

6. STOVE MAINTENANCE

NOTICE
To simplify this section, only the ECO-55 is
presented. Note that all the cleaning steps are
carried out the same way for the ECO-55 ST.

6.1 MAINTENANCE SAFETY

WARNING
HOT SURFACE. ALLOW TO COOL
BEFORE SERVICING.
DANGER
DISCONNECT ALL SOURCE OF
POWER BEFORE SERVICING THE
STOVE.
CAUTION
FAILURE TO CLEAN AND MAINTAIN THIS
STOVE AS INDICATED CAN RESULT IN
POOR PERFORMANCE AND SAFETY
HAZARDS.
NOTICE
Cleaning the stove and the venting system is
especially important at the end of the heating
season to minimize corrosion during the summer
months, caused by accumulated ash.
OPERATION MANUAL ECO-55 / ECO-55 ST