6.2.2 Loading documents
5.
Place the documents on the feed tray with the side to be scanned facing down.
•
Set the leading edge of documents as shown in the illustration ( ).
•
Insert the documents slowly until they stop.
1
Note
•
The height of the documents should not exceed the limit mark ( ) on the document guide.
Exceeding the limit mark may cause a paper jam or skewing.
•
When the paper is thin, it may not be fed properly due to curls in the paper. In that case, press the
front part of the exit support ( ) to use the exit support.
Notice
•
Be sure to use the exit support in the position as shown in the illustration. It may detach
from the unit if you try to pull it up more.
28
1