Preparatory Work - Dirt Devil BLADE 24V Instruction Manual

18

Preparatory work

Getting to know the appliance
Fig. : Handle with battery level indicator;
1
1
Wand release button;
2
release clip; Light on the turbo head;
5
with brushbar; Charging port (hidden);
7
held; Mains adapter;
9
ter cover; Battery level gauge;
12
Wall mount; Boost button;
14 15
cator; Dust collector
17
Accessories (optional):
Fig. : Crevice tool;
2
A
Parquet tool
D
Unpacking and assembling
Unpack the contents and check they are com-
1
plete. If you notice any transport damage or if any-
thing is missing, contact your dealer immediately.
Attach the turbo head or accessory to the reach
2
wand until it clicks into place (Fig.
Attach the reach wand to the handheld until it
3
clicks into place (Fig. ).
4
NOTE:
To use the appliance as a handhelt, attach the turbo
head or accessory directly to the handheld until it
clicks into place (Fig.
5
Attaching the wall mount
Choose a location to store the appliance, prefera-
1
bly near a mains socket.
with the wall mount (Fig.
and wall mount against the wall so that the turbo
head rests flat on the floor.
the position of the wall mount.
from the wall mount.
6
and make a mark for each screw.
wall plugs to screw the wall mount to the wall.
Charging the rechargeable battery
!
WARNING!
Risk of fire or explosion! Only use the mains
adapter included in the scope of supply to charge
the rechargeable battery.
NOTE:
You must charge your appliance before using it
for the first time. The initial charge takes 4 hours.
Failure to fully charge the rechargeable battery
before first use may result in poor battery perfor-
mance.
Reach wand; Accessory
3 4
Turbo head
6
Hand-
8
ON/OFF button; Fil-
10 11
Brushbar button;
13
Battery level indi-
16
Pet tool; Dusting brush;
B C
).
3
).
Connect the appliance
2
). Place the appliance
6
3
Use a pencil to mark
4
Remove appliance
5
Align wall mount to the wall
Use screws and
7
EN
Attach appliance to the wall mount. To charge the
1
appliance as a handheld, press wand release button
(Fig. / ), detach reach wand and accessories and
7
1
place handheld on a flat, stable surface.
the mains adapter cable to the charging port
(Fig. ). Connect the mains adapter to a socket
8
3
➔ The battery level indicators (Fig.
light up constantly in red. To indicate the charging
progress, the battery level gauge lights (Fig.
will illuminate in turn, until all four lights are illumi-
nated. After a maximum of 4 hours, the battery
4
level gauge lights go out and the battery level indica-
tors (Fig. 1 / & 9 /
1
➔ The rechargeable battery is fully charged.
connect the mains adapter from the socket (to save
electricity) and disconnect the mains adapter cable
from the appliance.
Vacuuming
!
WARNING!
Take extra care when vacuum cleaning on stairs.
NOTE:
When the battery is almost flat the appliance
will switch itself off within a few seconds. Fully
charge the rechargeable battery, > „Charging the
rechargeable battery" on page 17.
NOTE:
Constant use of the boost mode and brushbar
will reduce the battery runtime.
Assemble required accessory, > "Unpacking and
1
assembling" on page 18.
ance, press the ON/OFF button (Fig.
appliance starts in boost mode. To switch between full
and reduced suction power, press the boost button
(Fig. / ). To switch the brushbar on/off, press
10
3 3
the brushbar button (Fig.
NOTE:
If the brush bar is blocked, the appliance will switch
off and the lamp on the turbo head will flash red
(Fig. 1 / ). Press the ON/OFF button (Fig.
5
to switch off the appliance and clean the turbo
head, > "Removing blockages" on page 19.
To switch off the appliance, press the ON/OFF but-
5
). ➔ The appliance switches off.
ton (Fig. /
10
1
Connect
2
/ &
1 9
1
9
) light up constantly in white.
2
5
To switch on the appli-
2
). ➔ The
/
10
1
/ ). Vacuum.
10
2 4
10
/ )
2
/ )
1
Dis-
/ )
1