ProForm PFTL79007.0 User Manual page 22

HOW TO ADJUST THE CUSHIONING SYS-
TEM
Remove the key from the console and unplug
the power cord. The treadmill features a cush-
ioning system that reduces the impact as you
walk or run on the treadmill. To increase the firm-
ness of the walking platform, step off the treadmill
and slide the cushion adjusters toward the front of
the treadmill. To decrease the firmness, slide the
cushion adjusters toward the back of the tread-
mill. Note: Make sure that both adjusters are
set at the same firmness level. The faster you
run on the treadmill, or the more you weigh,
the firmer the walking platform should be.
Cushion
Adjustor
Increase
Decrease
Cushion
Adjustor
Walking Platform
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor offers hands-free oper-
ation as it tracks your heart rate during your workouts.
To purchase the optional chest pulse sensor, call
the telephone number on the front cover of this
manual.
If you purchase the optional chest pulse sensor,
follow the steps below to install the receiver in-
cluded with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 3/4" Screw (12) and the
Access Door (87) from the Console Base (93).
2. Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Base (93).
Hold the receiver so that the small cylinder is
oriented as shown and is facing the Console
Base. Attach the receiver to the plastic posts on the
Access Door (87) with the two included small
screws.
3. Make sure that no wires are pinched. Reattach
the Access Door (87) with the #8 x 3/4" Screw (12).
Discard the other wires included with the receiver.
Small
Screws
Small
Cylinder
22
Wires
93
A
87
12