ProForm PFTL79007.0 User Manual page 10

10. Set the Pulse Bar Bottom (95) on the Left
Handrail (35) and the Right Handrail (33). Press
the Pulse Bar Bottom forward as you tighten two
#10 x 3/4" Screws (5) with two #10 Star
Washers (10) into the Handrails.
Remove the long tie from the Upright Wire (38).
11. With the help of a second person, hold the con-
sole assembly near the Right Handrail (33) and
the Left Handrail (not shown).
Connect the Upright Wire (38) to the Console
Wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN YOU TURN ON THE
POWER. Insert the connectors and the excess
wire into the Right Handrail (33).
12. Connect the console ground wire to the handrail
ground wire.
Set the console assembly on the Right Handrail
(33) and Left Handrail (35). Make sure that the
wire harnesses are not pinched. Attach the
console assembly with two #8 x 1/2" Screws (1),
four #8 x 3/4" Screws (12), and four #8 x 1/2"
Washer Head Screws (112). Start all the
Screws before tightening any of them.
Cut the plastic tie from the Right Handrail (33).
10
35
10
11
33
12
Ground Wires
Plastic
Tie
112
33
12
10
Long Tie
5
5
95
10
33
Console
Console
Assembly
Wire
38
Console
Wire
38
Console
Assembly
12
112
12
1
38
35